ASWX2 - Update bed screws / BLTouch alignment

artillery-sidewinder-x2/klipper-cfg-files/printer.cfg

@@ -145,6 +145,7 @@ fade_start: 1
 fade_end: 10
 
 [bed_screws]
+# Nozzle / Screws alignment
 screw1: 50,50
 screw1_name: front left
 screw2: 250,50
@@ -156,13 +157,14 @@ screw4_name: back left
 speed: 100.0
 
 [screws_tilt_adjust]
-screw1: 23,63
+# BLTouch / Screws alignment
+screw1: 21,82
 screw1_name: front left
-screw2: 223,63
+screw2: 231,82
 screw2_name: front right
-screw3: 223,263
+screw3: 231,287
 screw3_name: back left
-screw4: 23,263
+screw4: 21,287
 screw4_name: back right
 speed: 100.0
 screw_thread: CW-M5
@@ -208,16 +210,16 @@ switch_pin: PA0 # the z-endstop pin
 #*# DO NOT EDIT THIS BLOCK OR BELOW. The contents are auto-generated.
 #*#
 #*# [bltouch]
-#*# z_offset = 3.099
+#*# z_offset = 2.999
 #*#
 #*# [bed_mesh default]
 #*# version = 1
 #*# points =
-#*# 	0.217500, 0.105833, 0.057500, -0.016667, -0.000000
-#*# 	0.176667, 0.081667, 0.023333, -0.018333, 0.012500
-#*# 	0.175000, 0.095000, 0.064167, 0.009167, 0.014167
-#*# 	0.220833, 0.136667, 0.061667, -0.008333, -0.028333
-#*# 	0.145000, 0.015833, -0.005833, -0.061667, -0.072500
+#*# 	-0.230833, -0.156667, -0.135000, -0.115833, -0.074167
+#*# 	-0.223333, -0.133333, -0.064167, -0.008333, 0.050000
+#*# 	-0.240000, -0.113333, 0.008333, 0.087500, 0.173333
+#*# 	-0.152500, -0.042500, 0.047500, 0.117500, 0.187500
+#*# 	-0.359167, -0.287500, -0.123333, -0.020833, 0.074167
 #*# x_count = 5
 #*# y_count = 5
 #*# mesh_x_pps = 3