artillery-sidewinder-x2/klipper-cfg-files/adxl345.cfg

@@ -1,4 +1,4 @@
-[mcu no_name_adxl]
+[mcu x_adxl]
 # Change <mySerial> to whatever you found above. For example,
 # usb-Klipper_rp2040_E661640843545B2E-if00
 serial: /dev/serial/by-path/platform-fd500000.pcie-pci-0000:01:00.0-usb-0:1.1:1.0
@@ -6,18 +6,18 @@ serial: /dev/serial/by-path/platform-fd500000.pcie-pci-0000:01:00.0-usb-0:1.1:1.
 
 
 [adxl345]
-cs_pin: no_name_adxl:gpio9
-spi_software_sclk_pin: no_name_adxl:gpio10
-spi_software_mosi_pin: no_name_adxl:gpio11
-spi_software_miso_pin: no_name_adxl:gpio12
+cs_pin: x_adxl:gpio9
+spi_software_sclk_pin: x_adxl:gpio10
+spi_software_mosi_pin: x_adxl:gpio11
+spi_software_miso_pin: x_adxl:gpio12
 
-axes_map: x,z,y
+axes_map: y,x,-z # x,z,y
 
 [resonance_tester]
 accel_chip: adxl345
 probe_points:
     # Somewhere slightly above the middle of your print bed
-    100,100, 20
+    150,150, 20
 
 #[output_pin power_mode] # Improve power stability
 #pin: adxl:gpio23

artillery-sidewinder-x2/klipper-cfg-files/printer.cfg

@@ -233,3 +233,7 @@ switch_pin: PA0 # the z-endstop pin
 #*# pid_kp = 38.998
 #*# pid_ki = 0.341
 #*# pid_kd = 1114.359
+#*#
+#*# [input_shaper]
+#*# shaper_type_x = mzv
+#*# shaper_freq_x = 49.0